Welcome to DaJing Lubrication Co., Ltd

Set ŻƱ | Add to Favorites | Back to ŻƱ
Electric lubrication pump
Hand (foot) dynamic lubrication pump
Manual (electric) gasoline pump
Distributor, oiler
Dry oil control, control valve and other accessories
Thin oil lubrication device and thin oil station
Thin oil lubricated parts
Oil and gas lubrication systems and devices
Electrical control box
Piping accessories
contact details
Phone: 0513-83660308
Fax: 0513-83660318
Mobile: 13767709919
Website: winvtech.com
Email: djrh888@163.com

You are here: ŻƱ> Products
SJB-V25 manual fuel pump (3.15MPa)

I. Overview

The pump is suitable for filling lubricant into the oil reservoir of a manual lubrication pump of 31.5MPa pressure level or a small electric lubrication pump of 40MPa pressure level. Because the pump has the characteristics of oil filtration, oil level display and easy operation, it is especially suitable for filling grease to the lubrication pump with no filter device in the oil reservoir supply port.

Technical parameters

Nominal pressure MPa
Oil supply mL / cycle
Handle force N
Oil storage tank volume L
Weight kg
The medium to be used is a grease with a penetration of not less than 220 (25 C, 150g) 1 / 10mm and a lubricant with a viscosity grade greater than N46.
Model description             

4. Dimensions

V. working principle
When the operating handle moves upward, the volume of the upper cavity of the piston gradually becomes smaller, and the lubricant is sent to the oil reservoir along the delivery hose. The lower part of the piston gradually becomes larger, forming a negative pressure. The lubricant is sucked in. When the handle moves downward, negative pressure is formed in the upper cavity of the piston, and the lower one-way valve is closed. The sucked lubricant cannot return to the oil drum. At this time, the upper one-way valve of the piston is opened, and the lubricant enters the upper cavity of the piston. When the handle moves up again, repeat the process.

Six, instructions for use
1. When in use, one end of the oil delivery hose is connected to the fuel pump outlet and the other end is connected to the oil reservoir replenishment port. After use, the other end should be screwed on the barrel cap bolt.
2.The filter should be cleaned regularly
3. Fat should be added to the barrel in time when the oil level is in the lower position, so as to prevent fat-free air from mixing into the oil reservoir.

Copyright Qidong Dajing Lubrication Equipment Co., Ltd. Copyright ? 2009 winvtech.com All Rights Reserved
Address: Chengdong Industrial Park, Qidong City Phone: 0513-83660308, 83905568 Fax: 0513-83660318 Email: djrh888@163.com